Also Available
Dynamiclear Rapid for Cold Sores
Visit Our Other Sites
For More Product Information:
For More Product Information:
Apply Dynamiclear only ONCE per outbreak
Dynamiclear is a powerful solution that will perform its task effectively with one simple application. If applied correctly, you should feel a stinging sensation as the Dynamiclear destroys all of the local viruses and begins to heal the symptoms rapidly. Re-apply the Dynamiclear at your next re-ocurrence, if necessary, or to any other sores that appear.
Apply Dynamiclear at the right time
Apply Dynamiclear only once during your outbreak, when the lesion is open and at the peak of its cycle. If your outbreaks never reach this "open" stage, simply apply the solution when your outbreak is most active (when it is at its worst).
Considerations if you are using Prescription Medications
If you feel more comfortable taking prescription medications with your Dynamiclear that is completely okay. There are no contra-indications in doing this.
Be sensible not to spread the virus
Keep the infected area isolated from skin that is free from the condition in order to prevent the virus spreading.
Do not spread the fluid from the blisters Use clean cotton tips and change the cotton tip for each area of application.
Allow the area to air dry.
Apply Dynamiclear to clean and dry skin
DO NOT use other topical products in combination with Dynamiclear..
Dynamiclear is a concentrated solution Dynamiclear should not be applied straight from the bottle without diluting.
To make an application simply:
1. Immerse a cotton swab (q-tip, cotton bud or cotton ball) in warm water
2. Squeeze out the excess water
3. Transfer a few drops of Dynamiclear to the cotton swab (enough to saturate it).
4. Proceed with the application steps outlined in the instructions
Please keep in mind that for the Dynamiclear to be effective, a mild to strong stinging sensation should still be felt, similar to an antiseptic lotion. If you feel no stinging sensation the application is too weak. In this case, try adding more drops ofDynamiclear with less water until a stinging sensation is felt.
Allow the scab to heal naturally and without disturbance. Once Dynamiclear is applied the area of application will rapidly dry up and the affected area should heal into a scab (except in some cases where the area is overly moist, in which case the area will close over without forming a scab). When the scab is forming you may feel a desire to scratch but please do not. After a short period of time the scab will fall off naturally to reveal normal healthy looking skin.
Apply to any future outbreaks that occur, if necessary.
Dynamiclear is a treatment that needs to be applied to each outbreak over a period of time for maximum results. If outbreaks continue it is important to apply Dynamiclear to each re-ocurrence, as per instructions.
